Make-noise MMG Bedienungsanleitung

MMG

TIPs and TRICKS: -To achieve classic Low Pass Gate sounds, use a complex audio signal source such as a Frequency Modulated SINE wave and apply Gate o

Calibrating the MMGRequires small flat head screw driver or trimmer tool, Square Wave reference signal, monitors. If available, an oscilloscope and DV

Calibrating the MMG (continued)Q (trimmer 3)1. Apply Square Wave at around 220hz (A3) to AC IN. Set FREQ to Full CW. Q and MODE to Full CCW. Set A

Limited WARRANTY:Make Noise warrants this product to be free of defects in materials or construction for a period of one yearfrom the date of purchase

Installation:The Make Noise MMG is an electronic signal generator requiring 50mA of +/-12V of regulated power and properly formatted distribution rece

Overview:The MMG is a Vactrol based Voltage Controlled Filter and Low Pass Gate using our QMMG core. The MMG bridges the Far East and West Coast synth

MMG Panel ControlsINPUT1A DC IN: Direct Coupled Input. Expects 10Vpp.2A AC IN: AC coupled Input. Expects 10Vpp.3A Over Load Indicator: Lights wh

MMG Panel Controls (continued)FREQuency1C STRIKE Input: Briefly opens the filter circuit to 100%. Expects 8 to 10V Gate or clock.2C FREQuency panel co

Filter and Low Pass Gate Basics:There are many different types of filters. The most commonly used filters in synthesizers are Low Pass, High Pass and

Understanding the MMG The MMG is no more complicated than other synthesizer filters, however it does have some features that are less typical. The I

Understanding the MMG cont. The Q-Factor control This is where the amount of resonance is programmed in the filter. Almost all music synthesizer filt